Ordering Replacement Parts; Technical Data - EINHELL ERL 500 Mode D'emploi

Anl. ERL 500 mehrspr.
GB
Worn out or damaged tine rollers should only be
replaced by an authorised professional (see address
on warranty certificate).
Do not clean the lawn aerator with running water,
particularly with high-pressure water.
Ensure that all mounting components (i.e. bolts, nuts,
etc.) are always tightened so that the lawn aerator
can be safely operated at all times.
Store your lawn aerator in a dry room. In order to
ensure that you enjoy your lawn aerator for many
years to come, all screwed parts, as well as the
wheels and axles, should be cleaned and lubricated.
Keeping your lawn aerator in good condition not only
ensures a long lifespan and
high-performance, but also enables the machine to
thoroughly aerate your lawn with minimal effort. For
best results, clean the lawn aerator with a brush or
rag. Do not use any solvents to remove dirt.
10. Replacing the tine roller
For safety reasons, we recommend having the tine
roller replaced by an authorized professional (see
address on warranty certificate).
Important! Wear work gloves!
Only replace the unit with a genuine Einhell tine roller
(see point 11, „Ordering replacement parts"), as this
will ensure top performance and safety under all
conditions.
If you decide to replace the tine roller yourself, follow
the steps listed below:
Switch off motor and let it run to a complete stop
Pull the power cable
Remove the wheels
Turn the lawn aerator belly side up to expose the
tine roller (Fig. 11)
Unscrew both plastic tine roller guides (Fig. 11,
points B and C)
Flip the lawn aerator over again and unscrew the
9 screws (Fig. 3, points D)
Remove the black motor cover plate
Unscrew both screws of the motor bracket and
remove the bracket
Lift up the motor and remove the V-belt
The tine roller (Fig. 11, point A) can now be
replaced
18
30.10.2002 20:33 Uhr Seite 18
Assemble in reverse order
At the end of the season, perform a general
inspection of the lawn aerator and remove any grass
and dirt which may have accumulated.
At the start of each season, ensure that you check
the condition of the aerator.
If repairs are necessary, please contact one of our
customer service centres (see address on warranty
certificate).

11. Ordering replacement parts

The following information should be given when
ordering replacement parts:
Model of machine = ERL 500
Art. No. of machine = 34.202.10
ID No. of machine = 01022
Replacement part number of the required
replacement part = e.g. tine roller = 34.055.59

12. Technical data

Voltage:
Power consumption:
Two-hand safety switch with switch/plug block
Working width:
Number of tines:
Height adjustment:
Tine roller with ball bearings
LPA sound pressure level:
Vibration on the handle
230 V ~ 50 Hz
450 W
32 cm
42
3-fold
78,5 dB(A)
< 2.5 m/s
2