Unpacking; Requirements For The Installation Location; Before The First Use - Graef WK 401 Mode D'emploi

Switch the unit on only after you have filled it with water. Use cold
●
water only.
The lid of the unit must always be firmly closed.
●
Make sure the unit is switched off and is not connected to the
●
mains.
Do not use any aggressive or abrasive cleaning agents and do not
●
use any solvents.
Do not scratch off stubborn soiling with hard objects.
●
Do not rinse the unit off in water or immerse it into water.
●

unPacKInG

To unpack the unit, proceed as below:
Take the unit out of the carton.
●
Remove all pieces of the packing.
●
Remove any possibly extant labels on the unit (do not remove the
●
rating label).

rEquIrEMEnts for thE InstallatIon locatIon

For safe and flawless operation of the unit, the place of location must
meet these prerequisites:
The unit must be set up on a firm, flat, level and non-slip base that
●
has sufficient load bearing capacity.
Make sure the unit cannot fall over.
●
Select the location so that children cannot reach the hot surfaces of
●
the unit and cannot touch the cable.

BEforE thE fIrst usE

Read these operating instructions thoroughly and keep them handy
for referral later on.
This unit brings water to boil in a few minutes.
To clean the unit, first fill the unit with clear, cold water and then
●
boil it. Subsequently pour away the water because of hygenical
reasons.
16