Publicité
10
FUNCTIONS WITH THE FENCE MANAGER
The measured information from the Fence Sensor and the settings in the Fence Manager are
both transmitted every 15 minutes. The information and functions shown in the Fence Manager
are explained in the following.
10.1 DISPLAY OVERVIEW – FENCE MANAGER
f
e
10.2 ALARM FUNCTIONS
The Fence Manager emits an alarm signal in the event of a voltage drop in the fence or a low
battery level in the Fence Sensor.
Voltage
The minimum voltage level (c) on the fence can be adjusted using the Fence Manager. The Fence
Manager emits an alarm signal as soon as the transmitted voltage falls below the set value (c).
I n fo
The Fence Sensor applies the settings as soon as the data has been transferred (after 15
minutes at max).
Battery level
The Fence Manager emits an alarm signal as soon as the Fence Sensor battery level (d) falls
below 10%.
NOTI CE
»
Replace the batteries within the next two weeks.
»
Only use batteries that are approved by the manufacturer.
11
CLEANING
N OTICE
»
Do not use aggressive solvents/detergents, brushes, sharp objects or similar
for cleaning, as they may damage the surface.
»
Do not immerse the device in water or other liquids. This may otherwise cause
a short circuit.
Use a damp cloth to clean the device if it becomes dirty.
22
a
b
d
INSTRUCTION MANUAL VOSS.FARMING FENCE SENSOR FS10
No�
Name
Connection quality between the
a
Fence Sensor and the Fence Manager
b
Fence voltage in kV
c
Set voltage level for the alarm in kV
d
Fence Sensor battery status
e
Time since last data transfer
c
f
Device type
41645 - 02.2025 - V03
Publicité
