Publicité
INSTRUCTION MANUAL VOSS.FARMING FENCE SENSOR FS10
7.3
PAIRING THE DEVICE WITH THE FENCE MANAGER FM10 OR FM20 WIFI
The device must be paired with the Fence Manager FM10 or FM20 WiFi in order to display the
Fence Sensor data.
Info
»
The Fence Sensor can only transmit data to one Fence Manager. It is not possible to
transmit data between different Fence Sensors or to more than one Fence Manager.
»
The Fence Sensor can only be paired with one Fence Manager. Any previous pairings are
immediately cancelled as soon as the device is paired with a new Fence Manager.
»
The Fence Manager can be paired with up to six resp. twelve Fence Sensors.
1. Place the Fence Sensor next to the Fence Manager at a distance of no more than 30 cm.
2. Switch off the Fence Sensor.
3. Hold the magnet against the magnetic point (3) on the side of the Fence Sensor for more than
three seconds.
The LED (1) flashes alternately green and red.
4. Pair the Fence Sensor with the Fence Manager as described in the Fence Manager FM10 or FM20
WiFi instructions.
Info
Pairing ends automatically after one minute. You can interrupt the process by holding the
magnet against the magnetic point (3).
Once successful pairing is complete, the LED (1) flashes green and you will hear an acoustic signal.
The Fence Sensor switches off automatically.
Info
The Fence Sensor is not yet connected to the fence and is not measuring voltage, so it
switches off automatically to avoid triggering an alarm via the Fence Manager.
The Fence Sensor is shown in the Fence Manager display with a reading of 0 kV.
The Fence Sensor is now paired and can be mounted at the selected point of the electric fence.
8
MOUNTING
Make sure that the device is coupled with the Fence Manager before mounting it on the fence.
WA RN I N G AGA IN ST E LE CTR ICAL VO LTAGES
Before performing any work on the electric fence, switch off the energiser battery
and ensure that the fence is not live to prevent injury due to electric shock.
N OTI CE
»
The device is suitable for outdoor use and is able to withstand normal weather
conditions.
»
Do not mount the device on the ground or in a damp, wet environment.
»
Do not expose the device continuously to water.
Info
Position the device in places where voltage measurement is required (e.g. fence passage)
or in places where problems are more likely to occur (e.g. due to heavy vegetation).
1. Switch off the energiser battery and the Fence Sensor.
2. Attach the base antenna (6) to the plug connector (2) on the device.
41645 - 02.2025 - V03
DE
EN
FR
IT
NL
SV
ES
19
Publicité
