Remote Commander - Sony VPL-CS10 Mode D'emploi

Symptom
On-screen display does not
appear.
Color balance is incorrect.
The picture is too dark.
The picture is not clear.
The picture appears too
small on the screen.
The picture flickers.
Sound
Symptom
No sound.
When sound is input
through AUDIO connector,
sound comes through one
channel only.

Remote Commander

Symptom
The Remote Commander
does not work.
The joystick, R CLICK, or
L CLICK key does not
function.
GB 34
Troubleshooting
Cause and Remedy
• STATUS in the SET SETTING menu has been set to OFF.
c Set STATUS in the SET SETTING menu to ON (see page 30).
• Picture has not been adjusted properly.
c Adjust the picture (see page 27).
• Projector is set to wrong color system.
c Set COLOR SYS in the PICTURE CTRL menu to match the
color system being input (see page 27).
• Contrast or brightness has not been adjusted properly.
c Adjust the contrast or brightness in the PICTURE CTRL menu
properly (see page 27).
• Picture is out of focus.
c Adjust the focus (see page 23).
• Condensation has occurred on the lens.
c Leave the projector for about two hours with the power on.
• SHIFT in the INPUT SETTING menu has not been adjusted
properly.
c Adjust SHIFT in the INPUT SETTING menu properly (see
page 28).
• DOT PHASE in the INPUT SETTING menu has not been adjusted
properly.
c Adjust DOT PHASE in the INPUT SETTING menu properly
(see page 28).
Cause and Remedy
• Cable is disconnected or the connections are wrong.
c Check that the proper connections have been made (see page
16).
• Monaural sound is being input through the AUDIO connector.
c Input stereo sound.
Cause and Remedy
• The Remote Commander batteries are dead.
c Replace with new batteries (see page 14).
• The front/rear remote control detector is near the fluorescent lamp.
c Change the setting of SIRCS RECEIVER in the SET SETTING
menu (see page 30).
• The mouse port on the computer does not recognize the mouse
cable.
c Restart the computer.