Storing The Machine In The Vertical-Stow Position - Toro 21863 Mode D'emploi

Figure 20
5. To unfold the handle, refer to
Handle (page 9).
Storing the Machine in the
Vertical-Stow Position
You can store your machine in the vertical position to
minimize storage space.
WARNING
Folding or unfolding the handle improperly
can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
1. Remove the electric-start button and battery
from the machine.
2. Ensure that the cutting-height setting on the
machine is 92 mm (3-5/8 inches) or lower; if it is
not, lower it; refer to
(page 13).
3. Disengage the handle locks
All manuals and user guides at all-guides.com
2 Unfolding the
Adjusting the Cutting Height
(Figure 21).
4. Fold the handle fully forward.
Important:
of the handle knobs as you fold the handle.
5. Engage the handle locks.
6. Lift the front of the machine by the handle and
move it into a storage space
g251299
19
Figure 21
Route the cables to the outside
(Figure
Figure 22
g251585
22).
g251586