Wifi Settings - Watts Vision Wireless Bt-St03 Rf Guide D'installation Et D'utilisation

Heating/cooling mode man-
4
agement menu. See section
"Heating and cooling control"
User settings menu.
5
In this menu, you can set:
• Time, Date (Manual, Automatic).
• Time and date if the device is in manu-
al time update mode.
• Summer-Winter (Manual, Automatic).
• Temperature unit (°C, °F).
• Backlight brightness
• Screen saver (Enabled, Disabled).
• Factory default user (interface).
WIFI menu.
6
Reading button (refreshment).
The Internet access password allows to
link your smart thermostat to your Internet
account (See below) for a remote control of
your system through the Internet or smart-
phone.
n.b.: At first use or software update, wait for
some time until the green State icon is active.
7 General commands menu. Use
this menu to put all the same devices
type in the same operating mode.
8
A

WIFI settings

To set the Wi-Fi configuration (SSID
and password), you can do it manually
or by scanning active networks.
Configuration requesting a registration
on a web page is not supported.
8
Installation menu
(Long press)
A
B
C
D
E
F
G
H
I
J
Wi-Fi status:
0/2 : Smart thermostat is not connect-
ed to the Wi-Fi router
1/2 : Smart thermostat is connected to
the Wi-Fi router but not to the server
2/2: Smart thermostat connected
to the Wi-Fi router and to the server
(pairing of the smart thermostat to an
account is required)
n.b.: The connection to Internet is rec-
ommended with Certified Wi-Fi routers
(http://www.wi-fi.org/certification).
n.b.: For the network scan, repeat
at least twice the operation if your
desired Wi-Fi network is not displayed.
If your desired Wi-Fi network is still
not displayed, enter the Wi-Fi settings
manually.
BT-ST03-RF-IOM-FR-W-EN-08-24
EN