Publicité
To delete a
room (zone).
Scroll over rooms.
3.4 Pair your devices to the
smart thermostat
• Install your devices (see relevant device
manuals)
• Create the room if it doesn't exist (See
section 3)
• Go to Radio pairing
• Choose the device type (heating, On/Off
device, etc)
• Choose the room
• Put the device in pairing mode (refer to
the device manual)
• Start the pairing on the smart thermostat
• Follow the instructions given by the
smart thermostat (check on the device
that the pairing is successful, refer to the
device manual)
• n.b.: Automatic pairing time in case of
RF communication loss: 10s.
10
Current room name
To create or
add a room
(zone).
To change current room (zone) name.
• When you have finished pairing all devic-
es, please check that the range allows
good communication. To do this, adjust
the setpoint temperature on the smart
thermostat and make sure that the infor-
mation is received by the thermostat/
receiver.
• Check the successful installation
In the radio pairing menu, choose test RF
installation.
You will have warning
menu for RF errors communications. The
warning flag should appear for a maximum
of 10mn. It would then disappear if there
are no communication problems. If not,
check devices showing RF errors, try
moving them to another place and repeat
the procedure.
BT-ST03-RF-IOM-FR-W-EN-08-24
EN
in home
Publicité
