Facom FCF894 Notice Originale page 26

Using an extension cable
An extension cord should not be used unless absolutely necessary. Use an approved extension cable suitable for the power input of your
charger. The minimum conductor size is 1mm
When using a cable reel, always unwind the cable completely.
Operation
WARNING: Always observe the safety instructions and applicable regulations.
WARNING: To reduce the risk of serious personal injury, turn unit off and remove the battery pack before making any adjustments
or removing/installing attachments or accessories. An accidental start-up can cause injury.
WARNING: Use only FACOM battery pack and chargers.
Installing and Removing the Battery Pack (Fig. D)
NOTE: Make sure your battery pack is fully charged.
To install the battery pack (6) into the tool handle, align the battery pack with the rails inside the tool's handle and slide it into the handle
until the battery pack is firmly seated in the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release button (5) and firmly pull the battery pack out of the tool handle. Insert it into
the charger as described in the charger section of this manual.
Variable Speed Trigger Switch (Fig. A)
To turn the tool on, squeeze the trigger switch (1). To turn the tool off, release the trigger switch. Your tool is equipped with a brake. The anvil
will stop when the trigger switch is fully released. The variable speed switch enables you to select the best speed for a particular application.
The more you squeeze the trigger, the faster the tool will operate. For maximum tool life, use variable speed only for starting holes or
fasteners.
NOTE: Continuous use in variable speed range is not recommended. It may damage the switch and should be avoided.
Forward/Reverse Control Button (Fig. A)
A forward/reverse control button (2) determines the direction of the tool and also serves as a lock-off button.
To select forward rotation, release the trigger switch and depress the forward/reverse control button on the right side of the tool.
To select reverse, release the trigger switch and depress the forward/reverse control button on the left side of the tool.
The centre position of the control button locks the tool in the OFF position.
When changing the position of the control button, be sure the trigger is released.
NOTE: The first time the tool is run after changing the direction of rotation, you may hear a click on start up. This is normal and does not
indicate a problem.
Proper Hand Position (Fig. F)
WARNING: To reduce the risk of serious personel injury, ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personel injury, ALWAYS hold securely in anticipation of a sudden reaction.
Proper hand position requires one hand on the main handle (4).
NU-FCF894_0518.indd 26
; the maximum length is 30m.
2
D
5
26
6
16/07/2018 16:12:35