Wall Mounting; Important Charging Notes; Storage Recommendations - Facom FCF894 Notice Originale

Wall Mounting

CL3.CH115
This charger is designed to be wall mountable or to sit upright on a table or work surface. If wall mounting, locate the charger within reach of
an electrical outlet, and away from a corner or other obstructions which may impede air flow. Use the back of the charger as a template for
the location of the mounting screws on the wall. Mount the charger securely using drywall screws (purchased separately) at least 25,4 mm
long, with a screw head diameter of 7–9 mm, screwed into wood to an optimal depth leaving approximately 5.5 mm of the screw exposed.
Align the slots on the back of the charger with the exposed screws and fully engage them in the slots.
Charger Cleaning Instructions
WARNING: Shock hazard. Disconnect the charger from the AC outlet before cleaning. Dirt and grease may be removed from the
exterior of the charger using a cloth or soft non-metallic brush. Do not use water or any cleaning solutions.

Important Charging Notes

1. Longest life and best performance can be obtained if the battery pack is charged when the air temperature is between18 –24 ˚C
(65 ˚F and 75 ˚F). DO NOT charge the battery pack in an air temperature below +4.5 ˚C (+40 ˚F), or above +40.5 ˚C (+104 ˚F).
This is important and will prevent serious damage to the battery pack.
2. The charger and battery pack may become warm to touch while charging. This is a normal condition, and does not indicate a
problem. To facilitate the cooling of the battery pack after use, avoid placing the charger or battery pack in a warm environment
such as in a metal shed, or an uninsulated trailer.
3. If the battery pack does not charge properly:
a. Check operation of receptacle by plugging in a lamp or other appliance;
b. Check to see if receptacle is connected to a light switch which turns power off when you turn out the lights;
c. Move charger and battery pack to a location where the surrounding air temperature is approximately 18–24 ˚C (65 ˚F–75 ˚F);
d. If charging problems persist, take the tool, battery pack and charger to your local service centre.
4. The battery pack should be recharged when it fails to produce sufficient power on jobs which were easily done previously. DO NOT
CONTINUE to use under these conditions. Follow the charging procedure.
You may also charge a partially used pack whenever you desire with no adverse affect on the battery pack.
5. Foreign materials of a conductive nature such as, but not limited to, grinding dust, metal chips, steel wool, aluminum foil, or any
buildup of metallic particles should be kept away from charger cavities. Always unplug the charger from the power supply when
there is no battery pack in the cavity. Unplug charger before attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid.

Storage Recommendations

1. The best storage place is one that is cool and dry, away from direct sunlight and excess heat or cold.
2. For long storage, it is recommended to store a fully charged battery pack in a cool dry place out of the charger for optimal results.
NOTE: Battery packs should not be stored completely depleted of charge. The battery pack will need to be recharged before use.
NU-FCF894_0518.indd 24
SAVE THESE INSTRUCTIONS FOR FUTURE USE
24
16/07/2018 16:12:34