Menu General; Menu Color; Menu Image - Optelec TwinView Manuel D'utilisation

Optelec

5.4.1 Menu General

The menu General contains the submenu's Brightness and Contrast. The default value of
both Brightness and Contrast is 50%. To configure the brightness and contrast settings of
the TwinView:
- Select the channel of which you would like to change the brightness and contrast
settings by pressing the channel A or channel B button;
- Activate the menu by pressing the menu button;
- Select General by using the up and down cursor keys and activate the option by
pressing the A/B button;
- Select Brightness or Contrast and confirm the choice with the A/B button;
- To adjust the brightness and contrast, use the left and right arrow keys and confirm
the choice with the A/B button;
- Use the menu Exit or press the Menu button to leave this submenu.

5.4.2 Menu Color

The color temperature can be adjusted using the submenu Color. There are three settings
in this menu:
- 6500 Kelvin
- 9300 Kelvin
- Custom
The default setting is 6500 Kelvin. The change this, follow these steps:
- Select the channel of which you would like to change the color temperature by
pressing the channel A or channel B button;
- Activate the menu by pressing the menu button;
- Select Color by using the up and down cursor keys and activate the option by
pressing the A/B button;
- In the submenu Color, select Color again and confirm the choice with the A/B
button;
- To adjust the color temperature, use the left and right arrow keys and confirm the
choice with the A/B button;
- If you selected the custom color setting, the value for red, green and blue can be
adjusted individually;
- Use the menu Exit or press the Menu button to leave this submenu.

5.4.3 Menu Image

Please note: Optelec recommends not to change the settings in the Image menu. The
TwinView will automatically adjust all image settings when turning on the monitor.
Especially the Audio White Balance setting should not be activated, as that may offset the
color calibration of the TwinView.
The menu Image contains image adjustment settings for the VGA connections. If a PC or
video magnifier is connected using the DVI connection, the Image menu will not be
available and will be greyed out. The first item in the Image menu is Auto Adjust. Activating
this menu item will automatically configure the image settings. As the adjustment will take
place when turning on the TwinView, there is no need to activate this option.
TwinView
Page 16