The Twinview Menu Setup; Introduction; Activating The Menu; Navigating The Menu - Optelec TwinView Manuel D'utilisation

Table des Matières

Les langues disponibles

Optelec

5. The TwinView Menu Setup

The TwinView has two menu's: one menu for channel A and one menu for channel B. This

allows you to change all of the settings, such as brightness and contrast, per channel. For

instance, it is possible to increase the brightness and contrast for the PC output (channel

B) and decrease the contrast and brightness for the ClearView+ output (channel A).

To activate the menu, first select the channel (A or B) by pressing the A or B button. The A

button can be found to the left of the cursor keys, the B button to the right. Then press the

menu button located to the left of the On/Off switch – this will activate the menu for the

selected channel. All menu changes will only apply to the selected channel. Pressing the

menu button will close the menu.

Use the up and down arrows to navigate between the menu items. The A/B button located

in the middle of the cursor cross will activate the menu item or selection.

The main menu of the TwinView contains the following menu items:

General: to set brightness and contrast settings

Color: to adjust the color settings

Image: to calibrate the image (this option is only available when the input is set to

VGA)

Information: displays the resolution and frequency

Language: to select the preferred menu language

Settings: to configure the menu timeout

Factory defaults: to restore all settings to the factory default

Select DVI/VGA: to set the DVI or VGA port for the selected channel

Exit: to leave the menu

TwinView

Page 15

Table des Matières