Product Introduction; Product Installation; Instructions For Use - Roborock F25 Rt Mode D'emploi

Product Introduction

A
Vacuum Cleaner
A1
—Switch Mode
• Press: Switch between ECO/Max modes
• Press and hold for 2 seconds while
on standby: Turn on/off voice
messages / Adjust volume
—Power
• Press: Start/Pause
• Press and hold for 2 seconds while
on standby: Power off
—Self-Clean
• Press while charging: Start self-
cleaning and drying
• Press and hold for 2 seconds while
charging: Start drying
• Press while self-cleaning or drying:
Pause/Resume self-cleaning or
drying
Note: To stop self-cleaning or drying, press the
while charging.
A1-1—Speaker
A1-2—Handle
A1-3—Handle Release Hole
A1-4—Roller Release Tab
A1-5—Wheels
A1-6—Status Indicator
A1-7—Dirty Tank Release
A1-8—Dirty Tank Handle
A1-9—Dirty Tank
A1-10—Clean Tank Refill Port
A1-11—Clean Tank Release
A1-12—Clean Tank
A1-13—Roller
Drying & Charging Dock
A2
A2-1—Drying Tray
A2-2—Drying Air Outlets
A2-3—Charging Contacts
Power Cord
A3
Filter
A4
Maintenance Brush
A5
Note: The maintenance brush can be placed in the
groove at the back of the charging dock.
Status Indicator
A6
A6-1—Status Indicator
• Blue indicator: Normal operation
• Red indicator: Abnormality or error
button

Product Installation

B
Fitting the Handle
B1
B1-1—Connect the handle to the main body
until it clicks into place. The buttons
on the handle should face forward.
B1-2—To detach the handle, hold it firmly
and pull it out while inserting a hard
object into the handle release hole
B2
B2-1—Place the charging dock upside
Note:
left cord storage slot opening.
B2-2—Place the charging dock on a flat,
B2-3—The maintenance brush can be
Note:
locations or near any heat sources, such as bathrooms,
kitchens, and radiators.
C
Language Selection
Press and hold the
seconds to start language selection, then
press the
To confirm your selection, stay upon your
preferred language for 10 seconds or press
the
09
on the back of the main body to press
the release button.
Positioning the Charging Dock
down, connect the power cord to
the socket of the charging dock, and
loop the cord inside the cord storage
slot as required.
The power cord can exit from either the right or
hard floor and plug it in.
placed in the groove at the back of
the charging dock.
Do not place the charging dock in humid

Instructions for Use

and buttons for 3
button to change language.
button.