Routine Maintenance; Product Maintenance - Roborock F25 Rt Mode D'emploi

• Always place the vacuum cleaner back on the charging
dock after use to avoid leaving water stains on the floor.
Drying
When self-cleaning is completed, drying will
start automatically. During charging, press
and hold for 2 seconds to start drying
manually.
Notes:
• Drying will automatically start after self-cleaning
completes. Do not often start drying manually.
• Self-cleaning and drying are available only when the
vacuum cleaner is being charged and with a high
battery level.
• Stay away from the drying air outlets during drying.

Routine Maintenance

D
To maintain optimal performance of the
vacuum cleaner, refer to the following table
for routine maintenance:
Maintenance
Part
Frequency
Roller As needed
Filter As needed
Cleaner Head
and Dirty As needed
Water Pathway
Dirty Tank As needed
Charging Dock As needed
Part
Charging
Contacts
Clean Tank
Notes:
• The vacuum cleaner must be powered off or stopped
running, and the charging dock unplugged before you
clean or maintain them.
• The frequency of replacement may vary with the actual
situation. If abnormal wear occurs, replace the parts
immediately.

Product Maintenance

If this product is left unused for a prolonged
period of time, fully charge it, unplug it,
and store it in a cool and dry place. Do not
place it in humid locations or direct sunlight.
Charge it at least once every 3 months to
avoid battery overdischarge.
Replacement
Vacuum Cleaner
Frequency
Wipe and clean the vacuum cleaner with a soft,
3 months
dry cloth. Before cleaning, remove the vacuum
As needed
cleaner from the charging dock and power it off.
Dirty Tank and Filter
D1
N/A
D1-1—Uninstall the dirty tank, pull out the
tank cover, and remove the filter on
N/A
the tank cover. Use the provided
N/A
maintenance brush to clean the
debris on the filter. If the filter is very
Maintenance Replacement
Frequency Frequency
As needed N/A
2-4 weeks N/A
11
dirty, rinse it with cold water and
shake off the remaining water.
D1-2—Dry all the parts thoroughly before
reinstalling them back in place.
Notes:
• Allow at least 24 hours for the filter to dry thoroughly
before reinstalling it.
• Do not touch the filter surface with hands, brushes, or
sharp objects to avoid damaging it.
Clean Tank and Roller
D2
D2-1—Grip the clean tank handle, press the
release button, and gently pull the
clean tank upwards at a slight angle
to uninstall the tank.
D2-2—Rinse the tank bottom with clean water.
D2-3—Grab the roller release tab and pull
the roller out along the cleaner head.
Use the provided maintenance brush
to remove the dirt on the roller, then
rinse it with clean water.
D2-4—When you need to replace the roller,
pull the roller cap out of the roller by
grabbing the whole cap. Then, install
the roller cap to a new roller.
Notes:
• Use the maintenance brush carefully to avoid injury.
• When you detach the roller cap, do not pull it by its
handle.
• To prevent potential damage, keep the roller cap
attached while cleaning the roller.
D2-5—Reinstall the roller and clean tank.