Roborock F25 RT Mode D'emploi page 10

Filling the Clean Tank
C1
C1-1—Grip the clean tank handle, press the
release button, and gently pull the
clean tank upwards at a slight angle
to uninstall the tank.
C1-2—Open the cap of the clean tank refill
port, add tap water, and then close
the cap.
C1-3—Place the clean tank back to the
cleaner head. Push it down gently
until it clicks into place.
Notes:
• To avoid deforming the clean tank, only use cold water.
• To prevent corrosion or damage, do not use
any disinfectant and only use cleaning solutions
recommended by Roborock such as Roborock Floor
Cleaning Solution.
• To improve cleaning performance, we recommend
that you add a 1/4 bottle cap of the recommended
cleaning solution to a full tank of water for use.
Locking and Unlocking
C2
Lightly step on the cleaner head and hold the
handle. Push it to lock the vacuum cleaner,
and pull it to unlock the vacuum cleaner.
C2-1—Locked
C2-2—Unlocked
Starting the Vacuum Cleaner
C3
Pull the handle to unlock the vacuum
cleaner, and press the button to start it.
Lay-Flat Cleaning
C4
The vacuum cleaner can be laid flat to
clean under furniture. To lay it flat on the
floor, lower the handle while using the
machine. The available capacity of the dirty
tank decreases during lay-flat cleaning.
Therefore, it is recommended to empty the
dirty tank before cleaning under furniture.
Note: Always lay the vacuum cleaner flat with the buttons
on the handle facing up.
Mode Switching
C5
Press the button to switch between ECO
and MAX modes. The status indicator will
flash based on the current mode.
Standby and Power off
1. Press the button during cleaning to
pause the vacuum cleaner. It is now on
standby.
2. Lock the vacuum cleaner while on standby
so that it can stand upright on the floor.
3. If the vacuum cleaner is left idle for
5 minutes while on standby, it will
automatically turn off. To manually turn
it off, press and hold the
seconds while it is on standby.
Water Level Alerts
When the dirty tank is full during use, the
vacuum cleaner will provide audio and
10 10
visual alerts. In this case, empty the dirty
tank prior to resuming cleaning.
Note: When the dirty tank is full, the red indicator will
stay on.
Emptying the Dirty Tank
C6
C6-1—Hold the dirty tank handle, press the
release button, and pull out the dirty
tank.
C6-2—Gently pull out the tank cover, and
empty the dirty tank.
C6-3—Reinstall the tank cover. Tilt the dirty
tank, insert its bottom back in the
vacuum cleaner, and then push it
gently until it clicks into place.
Charging and Self-Cleaning
C7
1. Lock the vacuum cleaner while it is on
standby and place it on the charging
dock. Charging starts when you hear
the "Charging started. Please start self-
cleaning." voice massage.
2. Press the
self-cleaning.
3. After self-cleaning and drying are
completed, follow the voice message and
button for 2
empty the dirty tank timely to prevent odors.
Notes:
• Make sure that the clean tank and dirty tank are in place
for optimum self-cleaning and drying performance.
• The product is equipped with a built-in high-performance
lithium-ion rechargeable battery pack. To maintain
battery performance, keep the product charged for
normal use.
button to start/pause