AEG I64AV423FB Notice D'utilisation page 90

Problem
There is no sound when you
touch the panel sensor fields.
comes on.
comes on.
Heating up takes a long time.
and appear simultane‐
ously.
and appear simultane‐
ously.
and appear simultane‐
ously.
You hear a beep sound, the indi‐
cators above blink and
SenseBoil® does not start.
SenseBoil® does not work.
and a number come on.
9.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
90 ENGLISH
Possible cause
The sounds are deactivated.
Child Safety Device or Lock oper‐
ates.
There is no cookware on the zone.
The cookware is unsuitable.
The diameter of the bottom of the
cookware is too small for the zone.
Cookware is too small and receives
only a part of the power generated
by the cooking zone.
The power is too low due to unsuita‐
ble cookware or an empty pot.
The pot is empty or contains some
liquid other than water, e.g. oil.
There is too much or too little water
in the pot.
You boiled some food other than wa‐
ter and potatoes. The boiling point
was moved in time and SenseBoil®
could not work properly.
None of the cooking zones is ready
to be used with SenseBoil®. There
is some residual heat on the cooking
zones you want to choose or they
are still in use.
The power level of the hob is too
low.
There is an error in the hob.
Service Centre. Give the data from the rating
plate. Give also three digit letter code for the
glass ceramic (it is in the corner of the glass
Remedy
Activate the sounds. Refer to "Daily
use".
Refer to "Daily use".
Put cookware on the zone.
Use cookware suitable for induction
hobs. Refer to "Hints and tips".
Use cookware with correct dimen‐
sions. Refer to "Technical data".
For optimal heat transfer use cook‐
ware with bottom diameter similar to
the size of the cooking zone (i.e. the
maximum cookware diameter value in
"Technical data" > "Cooking zones
specification").
Use the appropriate type of cookware.
Refer to "Hints and Tips" and "Techni‐
cal Data".
Do not activate any zone with an emp‐
ty pot on it.
Avoid using the function with liquids
other than water.
Only boil water and potatoes with the
use of SenseBoil®. Refer to "Hints and
Tips".
Finish your previous cooking activities
and choose a free cooking zone with‐
out any residual heat.
Set the power level to a higher value.
Make sure that the selected power fits
the house installation fuses. Refer to
"Before first use" > " Power limitation".
Deactivate the hob and activate it
again after 30 seconds. If
on again, disconnect the hob from the
electrical supply. After 30 seconds,
connect the hob again. If the problem
continues, speak to an Authorised
Service Centre.
comes