Worx Landroid M Guide D'installation page 18

®
The Landroid M is running
out of the boundary wire
®
area. Landroid M can't
mow some area in the
marked zone, sometimes
go back or rotate when
close to this area.
®
Landroid M wheels skid or
wheels rip the grass up.
®
The Landroid M exits the
boundary wire due to high
speed when going down a
hill.
18
EN
Write your PIN code here:
The boundary wire of another Landroid
another branded robotic mower is positioned
too closely.
The boundary wire has been installed with
sharp corners.
Electric current may leak in the joint between
boundary wires due to a broken or wet
connection.
There is leakage of electric current in the
wire due to a broken insulation layer.
The cutting area is far more than the
declared area.
®
Landroid M cover is stuck by branches and
followers, which may result in skipping when
it hits obstacles.
Rain or irrigation makes the grass wet.
The Boundary Wire is placed on a slope
steeper than 15°.
®
M or
Ensure your Landroid
of spacing between the neighboring boundary wire.
Check the boundary wire to ensure the corners are
smooth.
Re-wrap the joint between boundary wires to ensure a
complete and waterproof connection
Re-wrap the damaged insulation layer to ensure a
complete and waterproof boundary wire.
Divide your lawn to separated areas, and mow them
respectively.
Make sure to clear up the branches or followers inside
®
Landroid M's cover, and surround the branches or
followers as an island to avoid further damage.
Please mow the grass when the grass is dry.
Reposition the Boundary Wire away from slopes that
are steeper than 15°. Please refer installation manual for
details.
®
M Boundary Wire has at least 2 m