Worx Landroid M Guide D'installation page 14

Open the panel cover, press
power button,
then input the default PIN
Press the key and close
the control panel cover: your
Landroid M will now
®
09:00pm
09:00pm
find its way to the charging base. Wed. 6-8-2012 Wed. 6-8-2012
M T W T F
M T W T F S S
7:00am ~ 12:00am
7:00am ~ 12:00am
Watch the Landroid
it returns to the charging
base and modify the
positioning of the boundary
wire if necessary. When the
Landroid M successfully
®
returns to the charging base,
this means the installation has
been successfully completed!
Now your Landroid
start to fully charge.
NOTE: If your Landroid
14
press the Start button to proceed with mowing.
EN
• If your Landroid
outside its territory, it will
not move and the display
Warning
will indicate "outside
the boundary" error.
Just move it inside its
territory and repeat
step 2.
NOTE: Please refer to the Programming and Troubleshooting Guide for more information.
2
0000.
09:00pm
Wed. 6-8-2012
S S
M T W T F S S
7:00am ~ 12:00am
M as
®
M will
®
M is in the charging base during a time you have programmed it to mow, press STOP , then simply
®
M is • If your Landroid
®
inside its territory but the
display says "outside
the boundary" and the
LED is on, it means you
clamped the boundary
wire ends incorrectly.
Just reverse them.
09:00pm
Wed. 6-8-2012
M T W T F S S
7:00am ~ 12:00am
M is • Your Landroid
®
always remain switched
on. If you ever need to
turn it off, then make sure
you place it within its
boundary area before you
switching it back on again.
09:00pm
09:00pm
Wed. 6-8-2012
Wed. 6-8-2012
M T W T F S S
M T W T F S S
7:00am ~ 12:00am
7:00am ~ 12:00am
M should • Should your
®
Landroid M stop
®
operating unexpectedly,
just press its ON/OFF
key to ON, correct the
problems, press Start
button.