Burkert 8045 Démarrage Rapide page 29

Adjustment, commissioning
K-FACtOR
OUtPUt
Fig. 23: Entering the K factor of the fitting used
→
If you do not want to adjust another parameter, go to the "END" parameter of the Parameters menu and press
not and go back to the Process level.
Type 8045
K=10.000
The display shows the K factor of the
fitting, may it have been entered or
determined by a teach-in procedure;
this K factor is currently used by the
device
→
Edit the parameter.
REtURN
K=2.8500
→
Enter the K factor (value between 0,0001 and
9999,9) of the fitting used.
→
Confirm the displayed value.
VALiD N/Y
Is only displayed if the K factor has been changed.
→
Confirm the entered K factor or not.
ENTER
to save the settings or
English
29