Fitting Instructions - R&G Lp0375 Instructions De Montage

Page 4 of 11
Picture 3
Picture 5
1. Remove the rear seat unit via the lock on the subframe & then rider seat.
2. Disconnect the rear indicator and number plate light connectors located under the pillion seat.
3. Remove the 2x rubber caps arrowed in Picture 1, and then remove the 4x bolts circled in Picture 1.
1. Remove all visible bolts from the tail unit and separate the two halves.
2. Unplug the indicators and number plate light, then remove the small wiring harness.
3. Once removed the tail units frame should be visible, remove the nuts holding the indicators in place
(as shown in Picture 2) along with any cable ties.
4. Re-assembly the tail unit without indicators and store.
1. Apply the supplied heat shrink (Item 10) or insulating tape to the indicator cables and supplied
number plate illuminator (Item 3) to cover any exposed wires, then attach the CON0013 (Item4)
to the licence plate illuminator bullet connectors.
2. Using the 4X M5 bolts, nuts & washers (Items 5, 6 & 8) assemble the licence plate bracket (Item
2) with the main mounting bracket (Item 1).
3. Using the supplied heat shrink or insulating tape, apply a small amount to the end of the indicator
wiring cover to stop it from moving (Picture 3).
4. Push the OEM indicator cables through the indicator brackets on the licence plate bracket (Item 2),
then through the holes in the main mounting bracket (Item 1).
5. Slide over the OEM nuts and washers, followed by the indicator wiring cover (Item 9).
Please note: The wiring covers may need to be cut at the tapered end in order to fit the
Unit
Tel: +44 (0) 420 89007 Fax: +44 (0)
1

FITTING INSTRUCTIONS

Removing the OEM Tail Bracket
Disassembly of the OEM Tail Unit
Assembly of the R&G Tail Tidy
, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
1
420 87301 www.rg-racing.com Email: info@rg-racing.com
1
connectors through.
R&G
LP0375
Picture 4
Picture 6