Checking The Blade; Testing The Battery; Operating The Lawn Mower; Holding And Guiding The Lawn Mower - Stihl Rma 239.1 C Notice D'emploi

English
► Pull the control bar with the left hand fully in
the direction of the handlebar and hold so the
thumb encloses the handlebar.
The blade turns.
► If 3 LEDs flash red: remove the battery and
consult a STIHL specialist dealer.
There is a fault in the lawn mower.
► Release the locking button and control bar.
The blade stops turning after a short time.
► If the blade continues to turn: remove the bat‐
tery and consult a STIHL specialist dealer.
The lawn mower is defective.
11.2

Checking the Blade

► Switch the lawn mower off and remove the
battery.
► Upend the lawn mower,
► Use a slide calliper (1) to measure the blade
thickness (a) at 5 points at least.
If the minimum thickness is fallen below:
replace the blade,
► Place a ruler (2) against the front blade edge
and measure grinding limit (b).
If the permissible grinding limit is reached:
replace the blade,
► If the sharpening angle is not correct: sharpen
the blade, 20.1
► If anything is unclear: consult a STIHL special‐
ist dealer.
11.3

Testing the Battery

► Press button on battery.
The LEDs glow or flash.
► If the LEDs do not glow or flash: Do not use
the battery and contact your STIHL servicing
dealer.
There is a malfunction in the battery.
2
Not available for all country variants.
42
16.1.
20.2
20.2

12 Operating the Lawn Mower

12 Operating the Lawn Mower
12.1 Holding and Guiding the Lawn
Mower
► Hold the handlebar with both hands so that the
thumbs enclose the handlebar.
12.2

Setting the cutting height

The following cutting heights can be set:
– 20 mm = position S
– 30 mm = position 1
– 40 mm = position 2
– 50 mm = position 3
– 60 mm = position 4
– 70 mm = position 5
The positions are indicated on the lawn mower.
Setting the cutting height
► Switch the lawn mower off.
The blade must not be turning.
► Place the lawn mower on a level surface.
► Hold the lawn mower at the handle.
► Push lever (1) away from the lawn mower
slightly and hold.
► Move the lawn mower to the desired position
by raising and lowering the lever.
The current cutting height can be read off at
cutting height indicator (2) by means of mark‐
ing (3).
► Release lever (1).
The lawn mower engages.
2
0478-131-9630-B