Talk Function; Sound Level Lights; Nightlight; Paging The Parent Unit - Philips AVENT SCD525 Mode D'emploi

6.2 Talk function

You can use the TALK button on the parent unit
to talk to your baby (e.g. to comfort your baby).
Press and hold the TALK button and talk
1
clearly into the microphone from a distance of
15-30cm (Fig. 23).
• The green LINK light starts flashing and the
message 'Talk' appears on the display.
Release the TALK button when you have
2
finished talking.

6.3 Sound level lights

The parent unit continuously monitors the sound
level in your baby´s room and the sound level
lights let you know if there is any activity. If your
baby cries, you see the sound level lights light up
on the parent unit.
•
As long as the baby unit does not detect a
sound, all sound level lights on the parent unit
are out.
•
When the baby unit picks up a sound, one or
more sound level lights on the parent unit go
on. The number of lights that go on is related
to the loudness of the sound picked up by the
baby unit.

6.4 Nightlight

Note:
D
You can also switch the nightlight on and off in
the menu of the parent unit (see chapter 'Menu
options', section 'Nightlight').
Press the nightlight button Q on the baby unit
1
to switch on the nightlight. (Fig. 24)
• Q appears on the display of the parent unit.
Press the nightlight button Q again to switch
2
off the nightlight.
• The nightlight dims gradually before it goes
out completely.
• Q disappears from the display of the parent
unit.
Tip:
E
Switch off the nightlight when you operate the
baby unit on the non-rechargeable batteries. This
saves power.
10

6.5 Paging the parent unit

If you have misplaced the parent unit and its
volume is switched off, you can use the PAGE
button on the baby unit to locate the parent unit.
Note:
D
The paging function only works when the parent
unit is switched on.
Press the PAGE button on the baby
1
unit (Fig. 25).
• The message 'Paging' appears on the display
of the parent unit.
• The parent unit produces a paging alert tone.
To stop the paging alert tone, press the PAGE
2
button again or press any button on the
parent unit.

6.6 Lullaby function

Note:
D
You can also operate the lullaby function in the
menu of the parent unit (see chapter 'Menu
options', section 'Lullaby function').
Press the play/stop button E on the baby unit
1
to play the currently selected lullaby. (Fig. 26)
• The lullaby starts to play and repeats
continuously.
To select another lullaby when a lullaby is
2
playing: (Fig. 27)
•
Press the lullaby button K on the baby unit.
•
Wait 2 seconds for the next lullaby to start.
•
If you want another lullaby, press the
lullaby button K on the baby unit again.
To stop the lullaby, press the play/stop button
3
E on the baby unit again. (Fig. 26)
6.7 Out of range alert
When the parent unit is out of range of the baby
unit, the parent unit beeps from time to time and
the messages 'Searching' and 'Not linked' appear
on the display. The LINK light on the parent unit
flashes red.
Note:
D
The message 'Not Linked' also appears on the
display of the parent unit when the baby unit is
switched off.