Operating Range; Adjusting Loudspeaker Volume - Philips AVENT SCD525 Mode D'emploi

• After 2 seconds the message 'Linked'
disappears and the temperature value is
shown on the display. (Fig. 17)
• If no connection is established, the LINK
light on the parent unit flashes red. The
parent unit beeps from time to time and
the message 'Searching' appears on the
display, followed by the message 'Not
Linked' (Fig. 18).
5.1 Positioning the baby
monitor
Place the baby unit at least 1 metre/3.5 feet
1
away from your baby (Fig. 19).
Place the parent unit within the operating
2
range of the baby unit. Make sure it is at least
1 metre/3.5 feet away from the baby unit to
avoid acoustic feedback (Fig. 10).
For more information on the operating range,
see section 'Operating range' below.

5.1.1 Operating range

The operating range of the baby monitor is 330
metres/1000 feet in open air. Depending on the
surroundings and other disturbing factors, this
range may be smaller. Indoors the operating range
is up to 50 metres/150 feet.
Note:
D
If the ECO mode is switched on, the operating
range of the baby monitor is also smaller. See
section 'ECO mode' in chapter 'Menu options'.
Dry materials
Wood, plaster, cardboard,
glass (without metal,
wires or lead)
Brick, plywood
Reinforced concrete
Metal grilles or bars
Metal or aluminium
sheets
For wet and moist materials, the range loss may
be up to 100%.
Material Loss of
thickness range
< 30cm/12in 0-10%
< 30cm/12in 5-35%
< 30cm/12in 30-100%
< 1cm /0.4in 90-100%
< 1cm/0.4in 100%
6 Features
The following features are described in chapter
'Menu options', as they can only be operated in
the menu of the parent unit:
•
Adjusting microphone sensitivity
• Sound alert on/off
• Setting room temperature range (minimum
and maximum temperature)
•
Temperature alert on/off
•
ECO mode on/off
•
Setting temperature scale (Fahrenheit or Celcius)
6.1 Adjusting loudspeaker
volume
Press the volume + or – button on the baby
1
unit until the desired loudspeaker volume for
the baby unit has been reached (Fig. 20).
Note:
D
You can only set the loudspeaker volume on
the baby unit when a lullaby is playing.
Press the volume + or – button on the parent
2
unit until the desired loudspeaker volume for
the parent unit has been reached (Fig. 21).
• The display gives visual feedback on the
volume settings of the parent unit: (Fig. 22)
•
Volume switched off/silent baby
monitoring
• Minimum volume
• Maximum volume
Note:
D
If the volume is set to a high level, the units
consume more power.
9