Festo DGEA Série Notice D'utilisation page 38

DGEA−...
Fitting the motor (not for right−angle gear units):
The motor flange (one or two parts, screws aG and aH in Fig. 17) is supplied
already mounted depending on your order. The coupling is then also mounted
fixed on the side of the axis.
With individual components (not for right−angle gear units):
S Note the torques in accordance with Fig. 16 and Fig. 17.
S Compare the shaft diameter [mm] of your combination with the specifica
tions in the following table:
MTR−... AC−55−...
DGEA−18−... (8/11)
DGEA−25−...
DGEA−40−...
Example:
6/12
Ø
ext
Ø
Ø *) = Outer diameter of the coupling [mm]
ext
Fig. 16
Commission the motor and the controller (preliminary comparison) in accordance
with the operating instructions.
38
AC−70−... AC−100−...
(11/12)
(15/24)
Ø
ST−87−... *)
jext
(8/11) 30
(11/11) 40
(15/20) 40
65
M
KSE
Festo DGEA−... 0501a English
M
KSE
2.9 Nm
10.5 Nm
10.5 Nm
25 Nm
M
KSE