Setting The Internal Clock - Scentys R'pulse 500 Manuel D'utilisation

S
ETTING THE INTERNAL CLOCK
The diffuser's internal clock is necessary for the diffusion calendar to operate properly.
n
Therefore make sure that the internal clock is correctly synchronised with the time at the place of installation.
n
CLOCK PARAMETER SETTING INTERFACE
Key
1
2
3
Access the internal clock setting menu:
Press
Press in normal operation to access the
parameter setting menu. is displayed.
Set the date on the internal clock:
NB: The day of the week changes by itself in Press
line with the selected date. Then press
Press or where necessary to change change the month.
the number of the day.
24/28
Parameter Description
Date Setting the day of the week / number of the day /
1
month / year.
Time Setting the hours / minutes / seconds
2
Calibrating drift The quartz that controls the logic module's internal clock
3
has a variable degree of drift every month depending on
the environmental conditions faced by the logic module.
Under standard conditions and excluding the
measured drift, leave this parameter set to 00.
until "CHANGER J/H" (CHANGE D/H)
Press to enter the clock setting menu.
to select the months. Pressr to select the years.
or where necessary to Then press or
change the year.
Set the time on the internal clock:
Press to select the hours.
Then press or
change the hours.
WARNING:
where necessary to
Press to select the minutes.
where necessary to Then press or where necessary to
change the minutes.
Do not change the drift calibration value unless otherwise advised by a Scentys
technician.
Once the parameters are correct, to return to the main menu, press
n
the parameter setting pages.
Press to select the seconds.
Then press or where necessary to
change the seconds.
to exit
25/28