SCENTYS R'PULSE 500 Manuel D'utilisation page 20

8/28
Insert the plugs flush into the wall
n
6
using a hammer.
Fit the mounting bracket making sure
n
7
that the holes match up with the plugs.
Insert four screws into the plugs, not
n
8
forgetting to insert a pressure washer
in between.
Start to tighten down the screws taking
n
care to ensure that the mounting
bracket is still horizontal using the spirit
level.
Finish tightening down the screws
n
9
while ensuring that the mounting
bracket has remained horizontal.
Check the mounting to ensure that it
n
10
is holding.
Do a dry run pump mounting to ensure
n
11
that the mounting bracket is ready to
accept the R'pulse 500 pump unit
(refer to the "Installing the Diffuser"
heading further on in this manual).
9/28