SCENTYS R'PULSE 500 Manuel D'utilisation page 23

WARNING: Fitting the safety sling is the installer's responsibility.
Its proper mounting is the installer's responsibility and Scentys cannot be held liable
for faulty installation.
When finalising the installation, it is essential to secure R'Pulse 500 pump unit mounting using a safety sling.
14/28
S
AFETY SLING
Run a loop around a fixed point in the
n
1
building structure (metal framework,
beam, ring sealed into the wall, etc.)
passing one end of the safety sling
through the opposite loop.
Make sure that no element can damage
n
the sling (protect sharp or abrasive
elements that may come into contact
with the sling).
Attach the sling's safety shackle to the
n
2
ring on the back of the diffuser.
WARNING: Only connect the power supply to the diffuser and start it up once all of the scent installation
equipment (R'Pulse 500 pump unit and S'Point 150 or S'Point 500 diffusion points) are correctly installed
(mounted, connected to the power and air supplies).
Once the entire scent installation is properly in place, proceed with start up and to adjust the R'Pulse 500 pump unit.
S
TART UP
Connect the power cord to the wall
n
1
power outlet provided for this purpose.
2
Check that the entire installation is
n
ready for start up.
Actuate the cut off switch on the back
n
and move it to position 1 and start the
diffuser.
n The diffuser will immediately start its
initialisation cycle (5sec.) then start the
diffusion cycle in line with the stored
parameter settings.
n The diffuser is then in operation and
can be set as required.
NB : The switch is accessible from below
if the pump unit is attached to the wall.
15/28