Installing The Wall Mount - Scentys R'pulse 500 Manuel D'utilisation

I
NSTALLING THE WALL MOUNT
WARNING: The wall mounting is the installer's responsibility.
Proper mounting installation is the installers responsibility and Scentys cannot be
held liable for faulty installation.
The R'Pulse 500 pump unit may simply be placed on a flat surface, on its four feet.
Ideally, it is preferable to solidly mount the R'Pulse 500 pump unit on the wall.
The R'Pulse 500 pump unit weighs 17kg and generates vibration. It is therefore preferable to choose strong concrete
or concrete block walls. The plugs and mounting screws used must be chosen to match the make up of the wall after
allowing for the constraints linked to the diffuser (weight, vibration, etc.).
6/28
Position the mounting bracket in the
n
1
location chosen for installing the R'Pulse
500 pump unit.
n Use a spirit level to check that the load
bearing surface is truly horizontal.
Mark the position of the four mounting
n
2
holes.
Remove the mounting bracket.
n
3
Drill the wall in the four places marked
n
4
using a drill bit suited to the type of
wall and the plugs used.
Insert the pugs into the newly drilled
n
5
holes.
7/28