Installation Requirements; Tools Required - Scentys R'pulse 500 Manuel D'utilisation

2
3
4/28
B P
UILDING ACK
For large area installations with air-conditioning, the
R'Pulse 500 pump unit coupled to an S'Point 500 diffuser
point will let you benefit from the full power of the
Scentys Building Pack solution.
O P
UTDOOR ACK
For outdoor installations, the R'Pulse 500 pump unit
coupled to an S'Point 500 diffuser point and a suitable
blower unit lets you use the solution's power for scenting
the outdoors.
For outdoor applications, diffuser accessories have to
be tailor made for each project so as to best match
the configuration.
I
NSTALLATION
The R'Pulse 500 pump unit must be installed in line with the following indications:
DIMENSIONS H 254mm x W 283mm x D 283mm
WEIGHT Gross: 17kg (box & accessories) - Net: 16kg
POWER Type of power supply: 220-240 V – 50-60 Hz
Power consumption: 300 W
DESIGN Materials / finish: Steel, sandblasted dark grey
FUNCTIONS Programmable: YES with bespoke programming via a built-in programmer
Adjustable diffuser intensity: YES by using the pause and diffuser timer settings
CONNECTIVITY Compatible with Scentys Controller software: NO
The pump must be installed so that it is stable and secure. Check that the installation support is able to bear its weight
and the vibration it causes. If the pump is suspended from its wall mount hook, it must be secured by its safety sling.
An electric power outlet must be provided close to the installation location.
The pump must remain accessible for adjustment and maintenance. If the pump is mounted in a closed space, an
access hatch must be provided close by (e.g. a 60 x 60cm opening in a hung ceiling or technical cabinet).
The pump produces heat so it should be mounted in a ventilated and unconfined space.
The pump must be located less than 25m from the farthest diffusion point.
T
OOLS
For installation:
R
EQUIREMENTS
R
EQUIRED
A spirit level
n
A drill suited to the wall to be drilled with its drill bit
n
Four plugs and four screws suited to the wall and the
n
weight and vibration characteristics of the pump
A hammer
n
A screwdriver suited to the screws
n
A 7mm socket wrench
n
5/28