SCENTYS R'PULSE 500 Manuel D'utilisation page 21

C
ONNECTING THE DIFFUSER
WARNING: The electrical connection must be made in line with applicable safety rules.
No matter how it is mounted, the pump unit must be connected to its power cord, the air output pipe and, if
required by the installation, to the distribution unit.
2
10/28
Prepare the blue Ø6mm compressed
n
1
air pipe cut to the desired length so
that it will supply air to the diffusion
point or the distribution unit and
connect it to the air connector on the
back of the unit.
Connect the distribution unit's electrical
n
2
connector (by pushing it in (1) and then
screwing it tight (2)).
1
Connect the electric power cord.
n
3
Check the mounting to ensure that it
n
4
is holding.
11/28