SCENTYS R'PULSE 500 Manuel D'utilisation page 22

I
NSTALLING THE DIFFUSER
WARNING: Wall mounting is only complete when the pump unit is locked onto the mounting
bracket by the two M4x10 hex head screws (supplied) provided for this purpose.
Once the pump unit is correctly connected, it may be placed in position then locked onto its mounting bracket.
12/28
Put the R'Pulse 500 pump unit into
n
1
place (push the back panel against the
mounting bracket, then leave the diffuser
free to slide down into position).
The cables must pass between the
n
mounting bracket arms.
Be sure to not pinch the cable or the
n
pipe between the R'Pulse 500 pump
unit and the mounting bracket.
Check that the hooks are properly
n
2
inserted into the lock holes on the
back of the pump unit.
Check that the centring pins are in
n
3
position in the holes provided under
the pump unit.
Fit the M4x10 hex head safety screws
n
4
(supplied) in the locking holes under
the unit.
n Using the 7mm socket wrench, firmly
tighten them down without applying
excessive force.
Check that the entire assembly is
n
5
solidly tied down.
13/28