Abicor Binzel CAT3 Mode D'emploi page 37

CAT3
12 Disposal
12.1 Materials
12.2 Consumables
12.3 Packaging
BAL.0324.0 • 2017-02-01
NOTICE
• Disassembly may only be carried out by qualified personnel
(in Germany see TRBS 1203).
• Please also consult the operating instructions for the welding components,
such as the power source and compressed air line.
• Observe the information provided in the following chapter:
 8 Putting out of operation on page EN-16.
 Fig. 7 Attaching the iSTM ECO to the robot on page EN-13
1 Remove the parts to be disconnected.
When disposing of the system, local regulations, laws, provisions, standards
and guidelines must be observed. Observe the regulations on the disposal of
electronic scrap and dispose of it at your local waste disposal site (e.g.
recycling center).
To correctly dispose of the product, it must first be disassembled. Please take
note of the following information:
 See 11 Disassembly on page EN-18
This product is mainly made of metallic materials, which can be melted down
in steel and iron works and are thus almost infinitely recyclable. The plastic
materials used are labeled in preparation for their sorting and separation for
later recycling.
Oil, greases and cleaning agents must not contaminate the ground or enter the
sewage system. These substances must be stored, transported and disposed of
in suitable containers. Please observe the relevant local regulations and
disposal instructions in the safety data sheets specified by the manufacturer of
the consumables. Contaminated cleaning tools (brushes, rags, etc.) must also
be disposed of in accordance with the information provided by the
consumables' manufacturer.
ABICOR BINZEL has reduced the transport packaging to the necessary
minimum. The ability to recycle packaging materials is always considered
during their selection.
12 Disposal
EN - 19