Electrical Connection; Technical Data; Assembly - Pelgrim OST 950 Notice D'utilisation

Electrical connection

Two or three phases.
L1 L2 N1 N2 L1 L2 L3 N
1 2 3 4 5 1 2 3 4 5

Technical data

oven type 990 970 950
model
combi-oven
with cooker electric gas
electrical connection
230 V
230 V
380 V/400V
50 Hz
nominal
power kW 3 9,9
Combination of oven 950/952 with Pelgrim
cooker (see Figure 6)
For installation of this combination appliance,
see the cooker instructions.
5 5 0
Solo oven 990/992 (see Figure 7)
Connect oven to the electrical mains.
Slide the oven into the cupboard.
Open the oven door and fasten the oven
with two screws on each side wall.
5 5 0
3
Combination of the 970/972 oven and the
Pelgrim electrical or ceramic cooker
After the electrical or ceramic cooker has
been installed in accordance with the
instructions supplied with the appliance:
Connect the oven to the electrical mains
and connect the cooker's 12-pole plug to
the oven's counter-plug.
Now slide the oven into the cupboard.
Open the oven door and fasten the oven
with two screws on each side wall.
Fig. 6

Assembly

Left- or right-hinged oven door
Remove the protective frame by removing
screws 1 and 2 (see Figure 8). Remove the
frame and replace screws.
1
2
Remove the upper hinge by removing the
two screws. Lift the door from the lower
hinge (see Figure 8a).
Fig. 7
Re-fasten the hinge to the door.
Turn the door around so that the handle is
on the other side.
Remove the hinge that is now at the top
(see Figure 8b). Attention: the ring belongs
in the lower hinge.
Slide the door into the lower hinge. Place
Fig. 8
the ring between the hinge and the hinge
holder (see Figure 8c).
Now reassemble the upper hinge.
Fig. 8a
Assemble the protective frame on the other
side of the oven.
Fig. 8b
Fig. 8c