Festool CT MINI I HEPA Notice D'utilisation D'origine page 14

English
9.2 Extracting wet materials/liquids
Remove the filter bag!
Use a special wet filter.
The dust extractor stops automatically when
the maximum fill level is reached.
The bottom LED [1-18] lights up red.
► Switch off the mobile dust extractor [1-11].
► Open the locking clips [1-10] and remove
the top section of the machine.
► Empty the dirt trap [1-9].
After wet extraction, allow the main filter to dry!
Dry the mobile dust extractor before extracting
dry dust.
CAUTION
Hazardous dust
Damage to the respiratory passage
► After extracting wet materials, remove the
wet filter and replace it with the main filter
for dry materials.
CAUTION
Escaping foam and fluids
► Switch off and empty the machine immedi­
ately.
9.3 Exhaust-air outlet
CAUTION
Hazardous dust
Damage to the respiratory passage
► Do not blow off any dust!
The exhaust-air outlet offers the option of di­
verting the exhaust air outside a building using
the suction hose.
► Open the grille in front of the exhaust open­
ing [1-14].
► Insert the suction hose in the exhaust open­
ing [1-14].
9.4 Cleaning the filter and filter bag
manually
► In standby mode, press the MAN but­
ton [1-17].
► Set the suction power to the maximum set­
ting [1-18].
► Cover the suction hose with your hand while
at the same time briefly pressing down the
cleaning lever [1-16] three times.
14
9.5 Changing the filter bag with minimal
dust
► Open the locking clips and remove the top
section of the machine [2].
► Pull the tab on the filter bag until the filter
bag opening is fully closed.
The filter bag is now securely closed and can be
removed.
► Fit the top section of the machine and close
the locking clips.
9.6 Changing the filter element[5]
► Pull out the used filter drawer [1-15].
► Dispose of the used filter drawer in accord­
ance with statutory regulations.
► Insert the new filter drawer [1-15].
5
Order numbers for accessories, filters and
consumables in the Festool catalogue or
online at "www.festoolusa.com".
NOTICE
Damage to the motor
► Never extract material without a main filter
or with a damaged main filter, as this can
damage the motor.
9.7 After finishing work
► Switch off the mobile dust extractor and
pull out the mains plug.
► Wind up the mains power cable.
► Empty the dirt trap.
► Place the suction hose [4-1] in the sealable
hose holder [1-7]. Place the mains power
cable [4-2] in the sealable hose hold­
er [1-7] or wind it up on the cord holder. To
do so, lay the power cable through the re­
cess [4-3].
► Vacuum and wipe the inside and outside of
the mobile dust extractor to clean it.
HF-CT MINI/MIDI-2
No.: 204201