Delivery And Installation; Unpacking And Checking Of The Delivered Parts; Installation Of The Certomat ® Is; Transport Protection - Sartorius Stedim Biotech CERTOMAT IS Mode D'emploi

2

Delivery and Installation

2.1

Unpacking and Checking of the Delivered Parts

1. For the transport to the working place please note the
weight of the shaker and the accessories included in the
delivery. Use only suitable transport means.
2. During unpacking carefully check whether the delivery
is complete, according to your order. Please check
carefully all parts for damages, that may be caused by
transport.
3. The mains supply at the working place must
correspond to the mains specifications of the shaker's
type plate and must have an earthed conductor.
Admissible mains supplies are 230 V, 50 Hz, 1.2 kW for
instance. Check on the type plate whether the shaker
has the correct power ratings.
•
Modifications of the CERTOMAT ® IS for different mains
supplies or changes of the mains cable according to
local standards will be done and checked in the factory
or by the Sartorius Stedim Biotech GmbH customer
service in place. The unit will be labeled
correspondingly.
If the CERTOMAT ® IS delivered to you has the wrong
4.
mains specifications, if any parts are damaged or are
missing or in case of malfunctioning, you should return
your claim note immediately to your Sartorius Stedim
Biotech GmbH representative or directly to Sartorius
Stedim Biotech GmbH.
Installation of the CERTOMAT ® IS
2.2
You can place the CERTOMAT ® IS on any sufficiently
1.
big and stable laboratory working place, e. g. common
laboratory tables. Please observe the dimensions, the
empty weight and the intended load. There must be
sufficient room for a convenient operation.
Dimensions:
Weight:
Load:
2. Make sure, that the base is stable enough to carry the
weight of the completely equipped shaker and can
resist vibrations caused by its operation.
The tray action causes vibrations at the shaker, which
cannot always be compensated by the internal balance
weight as regards loads and shaking speeds. Especially
at heavy loads (> 10 kg) and high shaking speeds the
vibrations can be transmitted to the working place.
6
W x H x D = 540 x 564 x 680 mm
75 kg without loading
(heating version)
depending on type of tray,
mounting system and shaking
vessels
3. The working place should have an antiskid surface. For
stable standing of the shaker during operation you may
clean the table and the stands with a wet cloth before
starting operation.
4. After placement of the shaker at the working place
carefully adjust the unit horizontally. An unbalanced
placement can result into faster wear and tear of the
internal drive, especially if the unit is often applied with
heavy loads and/or at high shaking speeds.
5. Place equipment around in such a way that it cannot be
interfered by the shaker's action.
2.3

Transport Protection

The CERTOMAT ® IS will be delivered without special
transport protection. The device is ready for use after
unpacking, connecting to the power supply and
equipping with the intended trays and mountings.