Sartorius Stedim Biotech CERTOMAT IS Mode D'emploi page 88

F2
•
The alarms which occurred are indicated on a list. The following information is separately disposed for each error type:
Error type
Error counter
Date / time /
alarm start
Date / time /
alarm end
•
An arrow marks the respectively active list entry.
•
In pressing the keys [+/-] the arrow can be moved.
•
In pressing the [ENTER] key the respectively active list entry is cancelled. Afterwards the alarm information for this kind
of error is not available any more.
•
If no alarm occurred or if all list entries were cancelled ["....<ESC>...."] appears on the display.
The diagnosis menu can only be quit with [ESC].
F3
In a list the alarm parameters for temperature, speed, door contact and voltage loss can be adjusted.
•
An arrow marks the respectively active parameter.
•
In pressing the keys [+/-] the arrow can be moved.
•
In pressing the [ENTER] key the YES / NO definitions are directly changed or the numeric values can be released for
modification (value flashes).
•
In pressing the keys [+/-] the respectively flashing value can be set.
•
In pressing the [ENTER] key the adjusted value is confirmed.
•
In pressing the [ESC]-key you jump back to the SETUP1-menu.
26
DIAG: Diagnosis of the alarm messages which occurred
e.g. speed or temperature alarm
Number of the alarms which occurred since the last acknowledgment
Date and time of the alarm start (only of the alarms which occurred last)
Date and time of the alarm end (only of the alarms which occurred last)
ALERTS: Alarm definition