Steinbach Poolrunner S63 Mode D'emploi page 9

outlet before cleaning, cleaning the fi lter or when it is not in use or
a fault has ocurred.
Never expose the control/power supply unit and the robot to high
temperatures or weather effects (rain etc.). Never immerse the
control/power supply unit in water for cleaning. Do not use the
robot with any cracks or fi ssures on the plastic components or
have deformed. Replace damaged parts only with suitable original
spare parts.
Check scope of delivery
NOTE! Risk of damage! The product may be damaged if you open the
packaging with a sharp knife or other sharp objects without due care
and attention. Please open the packaging very carefully.
■ Remove the product from the packaging.
■ Check that all included items have been delivered in full. Sketch/photo
L1.
■ Check whether the item, or parts thereof, exhibit damage. If there is
damage, do not use the product. Get in contact with the service ad-
dress stated at the end of the manual.
Cleaner Structure
Figure 1
Connecting cable
Figure 2,3,4
Description of control panel
Figure 5
Item Name Function
1 ON/OFF Power on or off
2 CYCLE
3 LED
Function of jet propulsion
Figure 6
Each on the front and on the back of the cleaner there are two
adjustable control nozzles for the drive in the water. The sucked foul
water is fi rst cleaned through the fi lter bag and then used for the drive
for the cleaner above the thrusters. The nozzles are adjustable,
depending on the size and pool type, to achieve the best cleaning
effect.
Control nozzles
The control nozzles can be set to angles between 0 – 40°. The cleaner
will move in a straight or curved line depending on the settings. The
0°/30° setting can be used for most pools. Figure 07
We recommend setting 20°/20° for round pools.
The above are recommending settings and operator can select a
proper nozzle direction based on above principle actual pool situation.
Brush installation
1
2
Brush disassembling
1
2
Detail
Power on or off
Stop after 1 hour
working, fi t for small
swimming pool.
Tip:
Stop after 1.5 hour
Suggest not using the brush in case it will not help you clean the pool
working, fi t for medium
(for example there is slope or too dirty on the pool fl oor).
swimming pool.
Stop after 2 hour
Since you have made your settings, you can put the cleaner carefully
working, fi t for large
and slowly into the pool. Please refer to the following pictures as the
swimming pool.
cleaner may be best placed in the pool. Figure 8, 9
The cleaner must always be committed or removed to the pool that
the underside of the cleaner facing the pool wall, to avoid possible
Flash by corresponding
scratches on the pool surface.
cycle, all indicators fl ash
after one cycle fi nish.
Care and Maintenance
Cleaning the fi lter bag, Figure 10, 11, 12, 13, 14, 15, 16
Tips and advices
■ Each time the cleaner is removed from the water, the fi lter element
has to be cleaned.
■ The pH-value of the pool water must be between 7.0 - 7.4.
■ The water temperature must be between 10 ° C and 32 ° C.
■ After pressing the „power off" button, the "power on" button can't be
pressed for 30 seconds.
■ We recommend to keep the cleaner between 5 ° C and 40 ° C in a
shaded, well-ventilated place. The supply cable must be wound up for
storage. (The fl oat on the cable must not be moved, so that a perfect
Press and install the brush into the corre-
sponding slot.
Make sure to install the brush tight.
Push out the brush bar from inside of
robot.
Take out the brush.
Commissioning
061007_v1908 EN
9