Steinbach Poolrunner S63 Mode D'emploi page 10

swimming of the cable in the water is maintained) Avoid direct expo-
sure to the sun all the time!
■ Before using, please read the instruction for fault rectifi cation thoro-
ughly.
■ Keep the cleaner always on the handgrip to remove it in and out of
the pool.
Trouble Shooting
Symptom Possible reason
The pool cleaner turns
while cleaning the
water (note, this is
normal).
Cable twists Obstruction in pool.
or
The cable in the water
coils up.
is too long.
Connecting cable is
not long enough.
Der Reiniger
kann
nicht alle
Stellen The pool shape
erreichen. doesn't make a
complete cleaning
possible.
The water cycle of the
bath is switched on.
Too much air in the
case.
The cleaner
does not work.
A foreign object is in/
at drive.
Important Note
Specifi cations:
■ Input voltage: 230 VAC
■ Frequency: 50 Hz
■ Output voltage: DC (direct current) 24 V
■ Rated power: 150 W
■ Working cycle: 1 h. / 1,5 h. / 2 h.
■ Cable lenght: 9 m
■ Maximum cleaning area in the swimming pool: 18 m
■ Filtering capacity: 18 m³/h
■ Filtering capablity: 180 μm
■ Working temperature (water): 10°C - 32°C
■ Water resistance class: Cleaner: IPX8, power control box: IPX5
■ Ambient temperatur: 10°C - 40°C
Service processing
Please do not send the unit unauthorized to us, but you should fi rst
contact our service center!
If the product needs to be picked up, so it is necessary to pack it safely
and enclose the invoice (copy) and a copy of the warranty card.
Once the unit has been returned to us, it will be checked for defects and
repaired of our complaints department. After completing this work, your
device will be returned to you as quickly as possible. If the submission
10
to guarantee isn't justifi ed, then the costs incurred will be charged. The
Warranty/Guarantee runs on the company Steinbach VertriebsgmbH.
The item will be repaired by the company Steinbach VertriebsgmbH,
because there exist no right of return, the pool cleaner will not be taken
back.
Cleaning
Use conventional cleaning products. Do not use solvent-based or abra-
sive cleaning agents/tools, i.e. no hard sponges, brushes etc..
Storage
Corrective action
The product must be thoroughly dried after cleaning. After which, it is to
be stored in a dry location protected from frost.
Unplug power line, complete
the cable and unscrew.
Disposal
Remove obstruction in pool.
Disposing of packaging: The packaging material has been selected
in view of environmental concerns and disposability and is therefore
Get the excess part of the
recyclable. The paper and cardboard can be recycled, as can the plastic
cable from the water. The
coverings.
cable in the water has to be
Disposing of the product: Applicable in the European Union and other
long enough to allow the
European states with systems in place for collecting and sorting recycla-
cleaner to reach all corners
ble materials. Dispose of the product in accordance with any laws and
of the bath.
regulations applicable at your place of residence.
Allow the cleaner to reach
all corners of the bathroom,
Warranty conditions
enter the maximum length
of the connecting cable
The respective country's legal provisions for warranty conditions shall
into the pool, but consider
apply accordingly.
a corresponding minimum
distance of the control unit
Declaration of conformity (CE)
to the pool.
Slide the pool cleaner by The EU declaration of conformity can be requested via the address
hand to the places shown at the end of this manual.
where was not cleaned and
restart manually backwards
forwards.
Turn off the fi lter pump.
Turn off the machine and let
all the air escape.
Contact the service center.
2
061007_v1908 EN