Starter System Test Results; Charging System Test Results - Bosch BAT 131 Notice Originale

4.6

Starter System Test Results

i
Press E to proceed with the charging system test,
press  to print the test results, press MENU to
return to the Menu.
Message
Action to be taken
CRANKING NORMAL The starter voltage is normal and the
battery is fully charged.
LOW VOLTAGE The starter voltage is low and the batte-
ry is fully charged.
CHARGE BATTERY The starter voltage is low and the batte-
ry is discharged. Fully charge the batte-
ry and repeat the starter system test.
REPLACE BATTERY Battery must be replaced before the st-
arting system can be tested.
NO START No vehicle start detected.
CRANKING SKIPPED A start was not detected.
SIDE POST Test data was inconclusive using the si-
de post. Retest using side post adap-
ters.
JUMP START POST Data was inconclusive using the Remo-
te post. Retest at the battery terminals.
i
For an in-vehicle test, the display alternates between
the test results and the message
CHARGING TEST .
Robert Bosch GmbH
4.7
i
Following the on-screen prompts:
1. Rev the engine.
2. Turn on high beams headlights and the blower fan.
3. Rev engine with loads on.
4. Idle engine and turn off loads.
5. The Charging System
6. Press  to print the test results or  to return to the
PRESS E FOR
Perform Test | BAT 131 | 9
Charging System Test
Once you have completed an in-vehicle test and the
starteter test, the display alternates between the
battery test results and the message
FOR CHARGING TEST . Press the E button to pro-
ceed with the charging test.
decision is displayed at the
end of the procedure.
Menu.
en
PRESS E
|
1 689 989 132 2013-09-09