Avintage AV22XI Notice D'utilisation page 26

1. Incline the wine cooler with 45 degrees, take out right lower hinge's screws with screwdriver
(Fig.1).
2. Level the wine cooler, hold the door and take out right upper hinge's screws with screwdriver, then
take out the door, put the door safety, unscrew 2 screws at bottom and remove the reed switch,
then install at top of frame, rotate door at 180 degree (Fig.2, Fig.3 & Fig.4).
3. Take off the decorated nail from left upper side then fit the door with screws then fit the decorated
nail to right side of A location (Fig.5 & Fig.6).
4. OPERATING INSTRUCTIONS
It is recommended that you installed your appliance in a place where the ambient temperature is
between 16-32°C (N class marked on the rating plate). If the ambient temperature is above or below
recommended temperatures, the performance of the unit may be affected and it may not be possible
to obtain temperature between 4-18°C.
26