Ash Removal; Service - SCAN Andersen 8 Manuel D'installation Et D'utilisation

5.4 Ash removal

This product has an ash pan that makes it easy to remove the
ash.
Fig.11
• The product is fi tted with an ash grate (Fig. 11-2). Activate
the handle (Fig. 11-1) to empty ash out of the burn chamber
into the ash pan (Fig. 11-3).
Important! Never empty ash into a fl ammable container.
There may still be embers in the ash long after the fi re has
gone out.
• Make sure that the ash pan (Fig. 11-3) never gets so full that
it prevents the ash from falling through the ash grate and
down into the pan.

6.0 Service

Warning! Any unauthorised changes to the product is not
allowed! Only original spare parts may be used!
6.1 Replacing the baffl e/defl ectors
Fig. 12
1
1. Lift the baffl e (Fig. 12-1) up carefully.
2. Remove the pins (Fig. 12-2).
3. Ease the baffl e out.
2
3
1
Fig. 13
1. Lift the exhaust defl ector (Fig. 13-1) up carefully.
2. Remove the pins (Fig. 13-2).
3. Ease the exhaust defl ector out.
6.2 Replacing the burn plates/inner
bottom
Fig. 14
2
1. Take out the baffl e/exhaust defl ector (see 6.1 - Replacing
the baffl e/exhaust defl ectors)
2. Take out the side burn plates (Fig. 14-1).
3. Take out the rear burn plates (Fig. 14-2).
Fig. 15
4. Lift out the ash grate (Fig. 15-1) and inner bottom plate
(Fig. 15-2).
5. When refi tting, follow the same procedure in reverse order.
ENGLISH
1
1
2
37