Menu; Setup Menu - OHAUS a-AB33M1 Mode D'emploi

Analyzer and Bench Meter

8. Menu

Touch the Menu icon
8.1

Setup menu

Enter this menu to set the meter/analyzer's parameters. The default settings are in bold.
Menu Sub-Menu
Mode
pH
(a-AB33M1,
a-AB33PH,
a-AB41PH)
Setup
Conductivity
(a-AB33M1,
a-AB33EC)
Temperature
Read type
Set the endpoint mode.
Auto-Stop
Continuous
Timed (a-AB41PH) = the meter/analyzer keeps measuring during the time period
Note: for detailed information about the three endpoint modes, please refer to
Measurement modes section.
Stability
Set measurement accuracy.
SmartStability
to enter the meter/analyzer's setup menu.
Table 8-1 Setup menu
Sub-Menu
Options
Read type
Stability
Average
Resolution
Buffer group
Cell K
Std.Solution
Ref.Temp.
Temp.Coeff.
TDS Factor
Temp.unit
Enter
temp.value
Temp.cal
(a-AB41PH)
= the meter/analyzer determines when the reading is stable and
reaches the endpoint automatically.
= the meter/analyzer keeps measuring and users manually end the
measurement.
users set.
= the meter/analyzer determines stabilization time automatically.
Options
Auto-Stop, Continuous, Timed (a-
AB41PH)
SmartStability, Fast, Medium, Slow (a-
AB41PH)
Auto Smart, OFF
0.1, 0.01, 0.001 (a-AB41PH)
USA, JJG, DIN, EU, Merck
0.01~10.0 (the default is 0.1 (a-AB33EC)
and 1.75 (a-AB33M1))
10 μS/cm, 84 μS/cm (a-AB33EC), 146.5
μS/cm, 500 μS/cm, 1413 μS/cm (a-
AB33M1) and 12.88 mS/cm.
20°C(68°F), 25° C(77° F)
0.0~10.0%/℃ (the default is 2.0%/℃)
0.01~5.0 (the default is 0.50)
° C, °F
5.0~60.0℃(41.0~140℉)
(the default is 25.0℃/77.0℉)
0~100℃ (32~212℉)
EN-23