Dual Channel Measurement (A-Ab33M1); Auto Endpoint Mode; Continuous Reading Mode - OHAUS a-AB33M1 Mode D'emploi

EN-20

5. Dual channel measurement (a-AB33M1)

a-AB33M1 model supports dual channel measurement. This mode helps users to
perform pH and conductivity measurement at the same time and view both
measurement results simultaneously through a split display.
5.1

Auto endpoint mode

When in Auto endpoint mode:
1. Press the
to blink during the measurement.
2. When the
reached the endpoint. The result will be automatically stored.
3. When the
and the measurement ends. The display will show the measurement result.
Note:
Touch the

or a computer.
 Press the
5.2

Continuous reading mode

When in continuous reading mode:
1. Press the
the icon start to blink during the measurement.
The blinking of the
exported continuously to a computer if you connect one to the analyzer, while the
result will not be stored to the analyzer.
Note:
During the export, the frequency of the pH channel is 2Hz, while the frequency of
the conductivity channel is 1Hz.
2. Press the
button to start the dual channel measurement. The
icon blinks twice, it indicates the reading of one channel has
icon blinks twice again, both channels have reached the endpoint
icon to print the result if you connect the analyzer to a printer
button to start a new measurement.
button to start the dual channel measurement. The
icon indicates that the measurement result will be
button to end the measurement.
Analyzer and Bench Meter
icon starts
icon and