Installation; Install The Stand-Alone Electrode Holder - OHAUS a-AB33M1 Mode D'emploi

EN-8

2. Installation

2.1

Install the stand-alone electrode holder

1. Attach the magnetic part on the bottom of the meter to the magnetic part on the
stand-alone electrode holder to finish installation. (Both marked in red
demonstrated below.)
2. The two tension knobs can be adjusted by turning clockwise to tighten or turning
counterclockwise to loosen. When they are loosened, you can move the holder up
and down, forward and backward to the desired angle. Then you can tighten the
knobs to fix the holder.
Analyzer and Bench Meter