Replacing The Lamp; Troubleshooting - Electrolux Rzb1010Aak Notice D'utilisation

7. First lift carefully and then remove
the glass panel.
8. Clean the glass panels with water
and soap. Dry the glass panels
carefully. Do not clean the glass
panels in the dishwasher.
When the cleaning is completed, install
the glass panel and the oven door.

10. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
10.1 What to do if...
Problem
The oven does not heat
up.
The oven does not heat
up.
The lamp does not oper‐
ate.
90°
2
1
Possible cause
The oven is deactivated.
The fuse is blown.
The lamp is defective.
When installed correctly the door trim
clicks.
Make sure that you install the internal
glass panel in the seats correctly.

9.5 Replacing the lamp

WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
cavity.
The back lamp
1. Turn the lamp glass cover to remove
it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
Remedy
Activate the oven.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp.
ENGLISH 17
A