PRO-POINT 9083577 Mode D'emploi page 16

9083577
PROBLEM(S) POSSIBLE CAUSE(S)
Motor shuts of
1. Internal thermal
during use
2. GFCI breaker has
Cable kinks 1. Too much force on
twists or
breaks
2. Too much slack
3. Cable is the wrong
4. The cable has been
5. Cable is worn out.
Cable 1. There's too much
tangles in the
drum
2. Motor is running in
3. The distributor tube is
Power cord 1. Motor direction switch
GFCI trips
when the unit
2. The power cord is
is plugged in
or when foot
3. Motor has short
switch is
pressed
4. Excessive moisture
5. Faulty GFCI unit.
16
Power-Feed Electric Drain Cleaner
protection switch or
auto reset breaker
has been activated.
been tripped.
the cable.
between the tool and
the drain inlet.
size for the pipe.
exposed to acid.
force on the cable.
reverse
frozen.
is defective.
frayed.
circuited.
on power cord or the
tool.
SUGGESTED SOLUTION(S)
1. Turn the motor off and allow it to
cool before restarting.
2. Ensure all electrical components
are dry and insulation is in good
condition. Press the reset button.
If GFCI trips again, contact a
qualified electrician.
1. Do not force the cable and let
the cutting tool do the work.
2. Move the tool to within 2 ft of the
drain inlet.
3. Use the correct cable size.
4. Clean and oil the cable.
5. Replace the cable.
1. Do not force the cable and let
the cutting tool do the work.
2. Retract the cable with the motor
direction switch in the forward
position.
3. Lubricate distributor tube
bearings.
1. Repair or replace the switch.
2. Repair or replace the power
cord
3. Have motor repaired or replaced
by qualified technician.
4. Dry the cord and unit.
5. Have an electrician replace the
power cord with GFCI.
For technical questions call 1-800-665-8685
V1.0