Installing Replacement Cable - Pro-Point 9083577 Mode D'emploi

9083577
4. Keep the tool clean, dry and free from oil/grease at all times.
5. Always ensure the tool is turned off and disconnected from its
power source before performing any inspections or maintenance.
6. Regularly inspect cutting tools to ensure their sharpness.
7. Inspect the switches and handles to ensure they move smoothly
and properly and that the bumpers at the bottom of the handle are
present and firmly attached.
8. Ensure the belt guard is in good working condition and fastened
securely.
9. Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or
others.
REMOVING AND INSTALLING BELT
1. Loosen the belt guard knob (B) and slide the belt guard (J) off
from the top of the tool's motor (#30).
2. Use a screwdriver to slide the old belt (#35) off the back of the
drum.
3. Slide the new belt into the belt pulley (#33) above the drum.
4. Slide the new belt onto the rear of the drum until securely in place.
5. Replace the belt guard and tighten the belt guard knob (B) to lock
into place.

INSTALLING REPLACEMENT CABLE

1. Remove the old cable (#5) by pulling the cable completely out of
the tool.
2. Separate the old cable from the drum-connecting cable (#6).
3. Connect the new cable to the drum-connecting cable.
4. Feed new cable back into the tool.
14
Power-Feed Electric Drain Cleaner
For technical questions call 1-800-665-8685
V1.0