Publicité
Les langues disponibles
Les langues disponibles
9083577
4.
Release all tension from the tension knob (I).
5.
Grab the cable with both hands and push into the drain at least 1 ft
deep.
6.
Re-tighten tension knob.
7.
Ensure that the power switch is in the forward position.
8.
Press the foot switch to begin feeding the cable farther into the drain.
8.1 Keep one handle on the cable at all times and ensure the
power switch and power feed lever are within reach.
9.
Once the drain is clear, turn on the faucets or use a hose to flush
any debris out.
9.1 Pay attention to the water level as there could be blockages
further down the line.
10. Retrieve the cable by placing the power feed lever in the reverse
position. Make sure the power switch is still in the forward position.
10.1 Keep one hand on the cable while retrieving to prevent the
cable from catching.
11. Continue retrieving until cable until tool is just inside the drain
opening and then release the foot switch.
11.1 Do not pull the cable from the drain while it is still rotating.
12. Turn the power switch off and disconnect the tool from its power
source.
13. Release feed knob tension and feed the remaining cable by hand
into the tool.
14. If results are as desired, store tool. If necessary, change cutting
attachments and repeat operation.
LODGED CABLE
If during operation the cable becomes lodged in a narrow part of the
drain or in a drain trap, accomplish the following:
1.
Place the power feed lever in the neutral position and allow the
cable to work itself past the obstruction.
2.
If cable remains lodged, release the foot switch and use sharp
downward thrusts to free the cable.
3.
Once the cable is free, place the power feed lever in the forward
position, press the foot switch and continue feeding.
12
Power-Feed Electric Drain Cleaner
For technical questions call 1-800-665-8685
V1.0
Publicité
