Assembly & Installation; Preparation - Pro-Point 9083577 Mode D'emploi

9083577
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1)
refer to the included Parts List.
Letter references in parenthesis (A) refer to
the included Identification Key.
Dashed numbers in parenthesis (Fig. 1-1)
refer to a specific point in an illustration or
image.
1. Slide the frame (A) into the designated
slots (Fig. 1-1).
2. Secure the in place using the handle
locking knobs (K).
OPERATION
TESTING
1. Connect the tool to its power source using the power supply cord.
2. Move the power switch into the forward position.
3. Position the feed lever (G) between the "F" and "R" settings.
4. Press the foot switch and note the rotational direction of the drum.
It should rotate clockwise when seen from the front, and it should
match the warning label and arrows displayed.
4.1 If the foot switch does not control the tool's operation, do not
use the tool until it is properly inspected and repaired.
5. Release the foot switch and let the drum come to a complete stop.
6. Move the power switch into the reverse position and repeat steps 4
and 5. The drum should rotate counterclockwise.
6.1 If the drum does not rotate the desired direction, do not use
the tool until it is properly inspected and repaired.
7. Switch off the tool and disconnect from its power source.

PREPARATION

Ensure that the tool is properly assembled and that all safety
precautions have been taken before moving forward with operation.
This includes the following:
10
Power-Feed Electric Drain Cleaner
For technical questions call 1-800-665-8685
V1.0
Fig. 1