Lubrication - Pro-Point 9083577 Mode D'emploi

V1.0
CLEANING
WARNING! Do not allow water to enter the tool and motor while
cleaning.
Clean the tool using hot, soapy water and/or disinfectants. Clean
regularly and always before storing for extended periods of time.
CLEANING THE CABLE
1. Thoroughly flush the cables with water after each use to prevent
build up of any sediment or chemicals.
2. Once fully flushed, carefully tip the tool forward to empty out any
remaining debris.
3. Once the cable is clean and dry, pull completely from the drum.
4. Lubricate with oily rages as you feed back into the drum.

LUBRICATION

Inspect and lubricate the tool when required. Only use light oil to
lubricate the tool. Other lubricants may not be suitable and could
damage the tool or cause a malfunction during use.
When not in use for an extended period, apply a thin coat of lubricant to
the steel parts to avoid rust. Remove the lubricant before using the tool
again.
NOTICE! NEVER use a penetrating oil to lubricate the tool.
Penetrating oil may act as a solvent that will break down the grease
and cause the tool to seize up.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or by-laws for
electronic devices, batteries, oil or other toxic liquids.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not
function properly or parts are missing. If unable to do so, have a
qualified technician service the tool.
Visit www.princessauto.com for more information
Power-Feed Electric Drain Cleaner 9083577
15